The Netgear EX7500 extender setup is mainly used to extend the range of your home wi-fi’s router and it also boosts the network speed to help you play online movies , Full HD online songs and full high definition graphics video games without any lag and buffering. It also helps you to set up your extender where you face poor connection of your network and dead spots.
There are few more steps to connect the Netgear New Extender setup and that are as follow :
Steps to set up Netgear EX7500 Setup Via WPS :
Plug-in your New extender setup into an electrical outlet to set up the netgear extender.
Make sure you place the router with your netgear extender in the same room.
Now , you have to see if the netgear extender is blinking green light if not then you have reboot the extender setup.
You have to grab a laptop or mobile phone or desktop then you have to open wifi’s settings and look for wifi named NETGEAR_EXT.
Then you have to press the WPS button i.e is on the front panel of your Netgear ex7500 setup.
Make sure you press the WPS button on the wi-fi’s router at the same time as the new extender setup.
Now it will start sighting solid green LED light and if it is not connected properly then it will sight solid red light and then you have to go through the previous steps again and follow them till the router is connected to the new extender setup.
Now you can move the netgear extender setup between the area where you were facing the poor connection and the dead spot and your home wi-fi’s router.
If it is connected and working properly as before it will sight green light and if not then it will sight red light .
No comments:
Post a Comment